(1) Strict vacuum sealing: It is well known in the past that the vacuum heat treatment of metal parts is carried out in a closed vacuum furnace. Therefore, the original leakage rate of the furnace is obtained and maintained to ensure the working vacuum of the vacuum furnace. It is very important to ensure the quality of vacuum heat treatment of parts. Therefore, a key problem of the vacuum heat treatment furnace is to have a vacuum sealed structure. In order to ensure the vacuum performance of the vacuum furnace, a basic principle must be followed in the structural design of the vacuum heat treatment furnace, that is, the furnace body should be airtightly welded, and at the same time, there should be as few or no holes on the furnace body as possible. Sealed structure to minimize the chance of vacuum leakage. The parts and accessories installed on the vacuum furnace body, such as water-cooled electrodes and thermocouple lead-out devices, must also be designed with a sealed structure.

(2) Most heating and heat insulation materials can only be used in a vacuum state: the heating and heat insulation linings of the vacuum heat treatment furnace work under vacuum and high temperature, so high temperature resistance and steam resistance are proposed for these materials. Low pressure, good radiation effect, low thermal conductivity and other requirements. The anti-oxidation performance is not high. Therefore, the vacuum heat treatment furnace widely uses tantalum, tungsten, molybdenum and graphite as heating and heat insulation materials. These materials are very easy to oxidize in the atmosphere, therefore, conventional heat treatment furnaces cannot use these heating and heat insulating materials.

(3) Water cooling device, vacuum heat treatment furnace shell, furnace cover, electric heating element conduction treatment (water-cooled electrode), intermediate vacuum insulation door and other parts, all work under vacuum and heating. Work under such extremely unfavorable conditions to ensure that the structure of each component is not deformed or damaged, and that the vacuum sealing ring is not overheated or burned. Therefore, each component should be equipped with water-cooling devices according to different conditions to ensure that the vacuum heat treatment furnace can operate normally and have sufficient service life.

(4) Using low voltage and high current: In the vacuum container, when the vacuum vacancy is in the range of a few Torr to lxlo-1 Torr, the energized conductor in the vacuum container will produce glow under higher voltage Discharge phenomenon. In the vacuum heat treatment furnace, severe arc discharge will be generated, which will burn down the electric heating element and heat insulation layer, causing major accidents and losses. Therefore, the working voltage of the electric heating element of the vacuum heat treatment furnace generally does not exceed 80-100 volts. At the same time, effective measures should be taken when designing the structure of the electric heating element, such as avoiding defective parts as much as possible, and the distance between the electrodes should not be too small to prevent the occurrence of glow discharge or arc discharge.

(5) High degree of automation: The reason why the degree of automation of the vacuum heat treatment furnace is higher is that the heating and cooling of metal workpieces require more than a dozen or even dozens of actions to complete. These actions are carried out in a vacuum heat treatment furnace and cannot be accessed by operators. At the same time, some actions such as the completion of heating and holding, the quenching process of the metal workpiece requires six or six actions and must be completed within 15 seconds. To complete many actions under such rapid conditions, it is easy to cause operator tension and constitute misoperation. Therefore, only a high degree of targeting can coordinate the actions in time according to the procedures.